Raynor 3240RGD Manuel du propriétaire télécharger pdf (Page 31)

*3-Button Remotes

If provided with your garage door opener, the large button is

factory programmed to operate it.

Additional buttons on any

SAFETY SIGNAL

3-button

remote or mini-remote can be

programmed to operate other

SAFETY SIGNAL

garage

door openers.

To Erase All Codes From Motor Unit Memory

To deactivate any unwanted remote, first

erase all codes:

Press and hold the “learn” button on motor

unit until the learn indicator light goes out

(approximately 6 seconds). All previous

codes are now erased. Reprogram each

remote or keyless entry you wish to use.

Press and hold the button on the hand-1.

held remote* that you wish to operate

your garage door.

While holding the remote button, press 2.

and hold the light button on the Multi-

Function Door Control.

Continue holding both buttons while you 3.

press the push bar on the Multi-Function

Door Control (all three buttons are held).

Release buttons when the motor unit 4.

lights blink. It has learned the code. If

light bulbs are not installed, two clicks

will be heard.

Press and release the “learn” button on 1.

the motor unit. The learn indicator light

will glow steadily for 30 seconds.

Within 30 seconds, press and hold the 2.

button on the hand-held remote* that you

wish to operate your garage door.

Release the button when the motor unit 3.

lights blink. It has learned the code. If

light bulbs are not installed, two clicks

will be heard.

To Add and Reprogram an Additional Hand-held Remote Control

Using the “Learn” Button Using the Multi-Function Door Control

LOCK

LIGHT

LOCK

LIGHT

Programming

Your garage door opener has already been programmed at the factory to operate with your hand-held remote control. The door will

open and close when you press the large push button.

Below are instructions for programming your opener to operate with additional SAFETY SIGNAL

315MHz remote controls.

NOTICE: If this SAFETY SIGNAL

garage door opener is operated with a non-rolling code transmitter, the technical measure in the

receiver of the garage door opener, which provides security against code-theft devices, will be circumvented. The owner of the

copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code transmitter to circumvent that

technical measure.

LOCK

LIGHT

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Commentaires sur ces manuels

Pas de commentaire

Raynor 3240RGD Manuel du propriétaire Page 31

Commentaires sur ces manuels

Produits connexes et manuels pour Ouvreur de porte de garage Raynor 3240RGD