Raynor 3240RGD Manuel du propriétaire télécharger pdf (Page 3)

To prevent damage to garage door and opener:

ALWAYS• disable locks BEFORE installing and operating the

opener.

ONLY• operate garage door opener at 120V, 60 Hz to avoid

malfunction and damage.

To prevent possible SERIOUS INJURY OR DEATH:

ALWAYS• call a trained door systems technician if garage

door binds, sticks, or is out of balance. An unbalanced

garage door may not reverse when required.

NEVER• try to loosen, move or adjust garage door, door

springs, cables, pulleys, brackets or their hardware, ALL of

which are under EXTREME tension.

Disable • ALL locks and remove ALL ropes connected to

garage door BEFORE installing and operating garage door

opener to avoid entanglement.

Preparing your garage door

Before you begin:

Disable locks.•

Remove any ropes connected to garage door.•

Complete the following test• to make sure your garage door is

balanced and is not sticking or binding:

Lift the door about halfway as shown. Release the door. If 1.

balanced, it should stay in place, supported entirely by its

springs.

Raise and lower the door to see if there is any binding or 2.

sticking.

If your door binds, sticks, or is out of balance, call a trained door

systems technician.

Tools needed

During assembly, installation and adjustment of the opener,

instructions will call for hand tools as illustrated below.

Pliers

Wire Cutters

Claw Hammer

Hack Saw

Screwdriver

Adjustable End Wrench

1/2" and 3/8" Sockets

and Wrench

Drill

Tape Measure

Stepladder

Pencil

3/16", 5/16" and

5/32" Drill Bits

Carpenter's

Level (Optional)

Sectional Door

One-Piece Door

1 2 3 4 5 6 7 8 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Raynor 3240RGD Manuel du propriétaire Page 3

Commentaires sur ces manuels

Produits connexes et manuels pour Ouvreur de porte de garage Raynor 3240RGD