Raynor 3800RGD Manuel du propriétaire télécharger pdf (Page 8)

Staples

Lock Screw

1/4-20 x 1/2" (2)

HARDWARE SHOWN ACTUAL SIZE

Figure 1

INSTALLATION STEP 3

Install Power Door Lock

The lock is used to prevent the garage door from

being manually opened once the door is fully

closed.

1. Select a door roller to mount the lock above.

Check for clearance. If possible select a roller on

the same side of the door as the motor unit. The

second roller up from the bottom is ideal in most

installations.

2. Ensure rail surface is clean and adhere lock

template to achieve a 3" (7.6 cm) distance

between the center of the roller and the pin hole

(Figure 1).

3. Drill holes as marked on the template.

4. Fasten power door lock to the outside of the garage

door track with hardware provided.

5. Run bell wire up wall to motor unit. Use insulated

staples to secure wire in several places.

6. Plug connector into the motor unit (Figure 2).

NOTE: Lock must be mounted within 10' of the power

head.

NOTICE

Overhand

Knot

Emergency

Release Handle

Overhand

Knot

Rope

Motor Unit

Emergency

Release Cable

To prevent possible SERIOUS INJURY or DEATH from a falling

garage door:

• If possible, use emergency release handle to disengage door

ONLY when garage door is CLOSED. Weak or broken springs

or unbalanced door could result in an open door falling

rapidly and/or unexpectedly.

• NEVER use emergency release handle unless garage

doorway is clear of persons and obstructions.

INSTALLATION STEP 2

Attach the Emergency Release Rope

and Handle

• Thread one end of the rope through the hole in the top

of the red handle so “NOTICE” reads right side up as

shown. Secure with an overhand knot at least 1"

(2.5 cm) from the end of the rope to prevent slipping.

• Thread the other end of the rope through the loop in the

emergency release cable.

• Adjust rope length so the handle is no higher than 6'

(1.83 m) above the floor. Secure with an overhand knot.

NOTE: If it is necessary to cut the rope, heat seal the cut

end with a match or lighter to prevent unraveling.

Figure 2

Lock Template

Roller

Garage

Door Track

TOP

DRI

LL 5/16"

DRILL

3/4

DRI

LL 5/

16"

132A2505

Approx. 3"

(7.6 cm)

TOP

/16"

132A2505

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 35 36

Commentaires sur ces manuels

Pas de commentaire

Raynor 3800RGD Manuel du propriétaire Page 8

Commentaires sur ces manuels